NF WF1946B - Page 112

4.3 Modulation
4-46 WF1946B
(2) Set the modulation DEPTH (width of amplitude variance)
① Use the
and keys to produce the following display (DEPTH flashes).
５０．０ ％
ＡＭ：ＴＹＰＥ ＤＥＰＴＨ ＦＲＥＱ ＦＵＮＣＴＩＯＮ
② Press the
ENTER
key.
③ Use the keypad or
MODIFY
dial to set the modulation depth.
For example, set to 33 %.
④ Press the
EXIT
key once to release the modulation depth setting mode
(3) Set the modulation FREQ (frequency with varying amplitude)
① Use the
and keys to produce the following display (FREQ flashes).
１００．００ Ｈｚ
ＡＭ：ＴＹＰＥ ＤＥＰＴＨ ＦＲＥＱ ＦＵＮＣＴＩＯＮ
② Press the
ENTER
key.
③ Use the keypad or
MODIFY
dial to set the modulation frequency.
For example, set to 200 Hz (5ms).
④ After setting, press the
EXIT
key once to release the modulation setting mode.