NF WF1946B - Burst Oscillation (Type: Trigger)

4.1 Burst oscillation
WF1946B 4-5
 Burst oscillation (Type: Trigger) (
MODE
→
BURST
→ TYPE : TRIG)
Burst oscillation (Type: Trigger) produces an intermittent oscillation output at a designated cycle at each
trigger signal.
Operation is described with reference to an example of producing a waveform output such as indicated in
the figure in response to an external trigger (
).
The example is a triangular waveform, DC offset 0 V, frequency and amplitude arbitrary.
Operation:
(1) Set the burst oscillation TYPE to TRIG.
① Press the
MODE
key, then the
BURST
key.
② Use the
and keys to select the type (TYPE flashes).
ＢＵＲＳＴ ＴＲＩＧ ＧＡＴＥ
4
ＢＵＲＳＴ：ＴＹＰＥ ＭＡＲＫ ＳＰＡＣＥ ＳＴＯＰ―ＬＥＶＥＬ
③ Press the
ENTER
key, then produce the following display with the and keys
(TRIG flashes).
ＢＵＲＳＴ ＴＲＩＧ ＧＡＴＥ
4
ＴＲＩＧ：ＴＹＰＥ ＳＯＵＲＣＥ ＤＥＬＡＹ ＭＡＲＫ
4
④ This sets the burst oscillation type to trigger. Press the
EXIT
key to exit type setting.