NF WF1946B - Basic Operation; Setting Initialize (PRESET)

3-16 WF1946B
3.3 Basic operation
Basic operation is described using an example of a triangular waveform with frequency 1 kHz, amplitude 2
Vp-p and DC offset +1 V from the waveform output connector.
Period (frequency): 1ms(1kHz)
 Setting initialize (PRESET)
The operation of initializing all settings is described. This operation manual presumes operation directly
after initializing.
Operation:
① Press the
SYSTEM
key, then use the and keys to produce the following display. (lower
PRESET flashes).
ＰＲＥＳＥＴ
ＳＹＳＴＥＭ：ＲＡＮＧＥ ＰＲＥＳＥＴ ＵＳＥＲ－ＵＮＩＴ
4
②
Press the
ENTER
key (upper PRESET flashes).
③ Again press the
ENTER
key to initialize. To return without initializing, before pressing
ENTER
,
press the
EXIT
key twice.