6.1 Error message
WF1946B 6-5
continued from previous page
Error message Cause and treatment
WARNING 009
Due to channel mode change, the oscillation mode was changed to
normal.
The sweep/modulation type was changed to frequency.
Therefore the other channel sweep/modulation was changed to
frequency.
Sweep/modulation type was changed to a type other than
frequency, or the oscillation mode was changed to other than
sweep/modulation.
Therefore, the oscillation mode of the other channel was changed
to normal.
WARNING 010
The sweep function was changed from LOG to LIN.
WARNING 011
The sweep mode was changed from gated to single.
WARNING 012
Since the oscillation mode of the other channel was changed
during sweep or modulation, sweep or modulation was stopped.
WARNING 013
Sweep time or modulation frequency exceeded the settable range
and was automatically changed to within the permissible setting
range.
WARNING 015
Because of DUTY-VALID change, the duty was changed to
0.01% or 99.99%.
WARNING 017
Because of a mode change, DUTY-VALID was changed to
IMMED.
To Next Page
Loading...
