4.2 Sweep
4-22 WF1946B
• During sweep, if the oscillation mode of the other channel is changed, sweep stops.
• To generate the trigger signal via remote control (GPIB or USB), set the GET command or TRG
command from the remote control interface.
For details of the remote control command,
“Remote Control Instruction Manual”, cf.
• To simultaneously operate sweep (start, stop, pause, restart) for both channels manually or via
remote control (GPIB or USB), set both channels to sweep mode and set OPER-COMMON to on.
If the BOTH lamp is on, behavior is the same even though OPER-COMMON is off.
ＯＦＦ
ＯＮ
Ｆ－ＳＷＰ：
3
ＯＰＥＲ－ＣＯＭＭＯＮ
To Next Page
Loading...
