NF ZM2371 - Page 177

5.6 Command Explanation
5-50 ZM2371/ZM2372
:FETCh?
Description: Queries the latest measured data.
For the data transfer format, see :FORMat[:DATA] command.
Response: When comparator function and limit comparison function are both
disabled
<measurement status>,<primary parameter measured value>,
<secondary parameter measured value>
When comparator function (bin sorting) is enabled
<measurement status>,<primary parameter measured value>,
<secondary parameter measured value>,<comparator’s bin
sorting result>
When limit comparison function is enabled
<measurement status>,<primary parameter measured value>,
<secondary parameter measured value>,<limit comparison
result>
The limit comparison result is output regardless of the setting of
comparator function (bin sorting). The bin sorting result of
comparator is not output.
The contents of respective data are as follows.
<measurement status>
0 No error
1 Either measurement error ERR, ALC error ALC Err, or
correction error CORR Err
2 Contact failure
3 Other any errors
<primary parameter measured value> and <secondary parameter
measured value>
{numeric value, format NR3, range ±9.99999E+11}
<comparator’s bin sorting result>
When bin extended function When bin extended function
is disabled is enabled
0 OUT_OF_BINS 0 OUT_OF_BINS
1 BIN1 1 BIN1
2 BIN2 2 BIN2
• • • •
9 BIN9 9 BIN9
10 AUX_BIN（S-NG） 10 BIN10
11 Sorting failed 11 BIN11
• •
14 BIN14
15 AUX_BIN（S-NG）
16 Sorting failed
AUX_BIN (S-NG): Output only when S-NG is used as auxiliary
bin.
:CALCulate:COMParator:AUXBin command
Sorting failed: Any error occurred or comparator function is
disabled.
When the bin extended function is enabled, the range exceeding
10 has different meaning.
:CALCulate:COMParator:EXTension[:STATe] command