Nice HySecurity SlideSmart HD - Page 56

DISPLAY AND MENU OPTIONS
Table 10. Smart DC Controller - Installer Menu Functions
Ref.
No.
User Menu
Display
Setting Options
(Bold = Factory
Settings)
Menu Tasks and Explanations
Associated
DC
Controller
Display
Connections
10
CH 0 (AC)
CHARGER TYPE
0 = AC powered
charger
1 = Solar
Assigns charger type usually set at
factory. If set to solar at factory then
this menu item is hidden.
(N/A)
11
BT 0 (STANDARD)
BATTERY TYPE
0 = standard (8Ah)
1 = extended
(50Ah)
2 = maximum
(110Ah)
Assign battery type used by
operator.
NOTE: Smaller batteries are
charged with less current to
avoid overheating and larger
batteries are charged with more
current to supply a more rapid
charge.
Extended
(50Ah)
batteries
require wire
extensions.
Maximum
(110Ah)
batteries
require
separate
housing and
wiring.
12
FO 0 (OFF)
FIRE DEPT OPEN
0 = disabled
1 = enabled
Enables Fire Department Open
input. When set to 1, signal received
through this input overrides all
photoelectric eyes and edge
sensors and opens gate. Pressing
RESET button (or the OPEN push
button) is required before gate can
be closed.
+24V DC
EMERG OPEN
13
SE 2
IES SENSITIVITY
0 = maximum
sensitivity
2 = default
Setting
9 = least sensitivity
Adjusts sensitivity of internal
inherent entrapment sensor (IES).
Available settings are 0 to 9 with
9 being least sensitive. HySecurity
strongly recommends that you
avoid setting IES sensitivity higher
than 6.
NOTE: Before changing IES
sensitivity, make sure that gate
rolls smoothly without obstruction.
Fix any issues with gate hardware.
See Note.
14
SS 0 (OFF)
IES STOP ONLY
0 = stop, reverse
for 2s
1 = stop only
In a Usage Class 4 environment,
operator can be set to stop gate
and not reverse gate travel after
an IES trip.
(N/A)
SlideSmart HD Programming and Operations
5656
support.hysecurity.com