Nidec MCE Motion 2000 Touch Screen - Page 107

Screen Descriptions
Manual # 42-02-1P28 A3 5-19
5
File
Transfer
Allows parameters to be backed up and restored:
- Backup Current Settings (to SD)
- Restore Backup Settings (from SD)
- Restore Factory Settings (from SD)
When option is selected, you are prompted to press OK to continue or EXIT to
abort without changing defaults
Register
Calls
On-board Car and Hall call registration controls. (Per car only)
Construc-
tion and
Bypass
Faults
- Construction/Fault Bypass
When active, enables Construction operation, bypasses faults. Also requires that
the Fault Bypass jumper on the HC-CTL-2 board be set to BYPASS and the car be
placed on Inspection mode
- Inspection Fault Bypass
When active, bypasses faults on Inspection operation. Also requires that the Fault
Bypass jumper on the HC-MPU-2-TS board be set to BYPASS
- Automatic Fault Bypass
Bypasses faults on Passenger operation. Also requires that the Fault Bypass
jumper on the HC-CTL-2 board be set to BYPASS. A countdown timer will appear
on the Home screen, counting down from 2 hours. When the timer expires, the
car will automatically exit fault bypass operation. If more time is required, must
be re-enabled
Safety Tests Compliance Testing (Future)
Date and
Time
Date, time and day of the week setting controls
Landing
System
Utilities
Hoistway Learn (Landing System Learn) - Allows you to learn the hoistway,
page 3-18. LS-EDGE only.
Landing System View - Displays position and speed information at upper and
lower leveling markers during floor leveling. Displays ON/OFF status for SDU
(Slow Down Up), ULMF (Up Level Marker, Front), ULMR (Up Level Marker, Rear)
DZF (Door Zone, Front), DZR (Door Zone, Rear), DLMF (Down Level Marker,
Front), DLMR (Down Level Marker, Rear), SDD (Slow Down Down). LS EDGE only
System
Inputs
On/Off status of dedicated inputs
System
Outputs
On/Off status of dedicated outputs
Pro-
grammed
Inputs
On/Off status of programmable inputs
Pro-
grammed
Outputs
On/Off status of programmable outputs
Front
CPI I/Os
On/Off status of CPI inputs/outputs
Rear
CPI I/Os
On/Off status of CPI inputs/outputs
Table 5.2 Touchscreen Organization and Content
Tab Subtab Description
UTILS
SYSTEM IO