Troubleshooting
6-24 Manual # 42-02-1P28 A3
Spare Inputs and Outputs
The first ten Spare Inputs (SP1 through SP10) are assigned to terminals SPIN1 through SPIN10
on the HC-CTL-2 board (connectors J6 and J10). The first four Spare Outputs (OUT1 through
OUT4) are assigned to terminals 1 through 4 (J15) on the HC-CTL-2 board. The remainder of
the Spare Inputs and Outputs are assigned to HC-UIO-2 boards numbered 32 through 36 as
shown in the table below.
* HC-UIO-2 Rev 2 will automatically configure the CAN port to communicate at 250k baud.
HC-UIO-2 Rev 4 - refer to Table 6.16 on page 21 to set switches 7 and 8 to communicate at
250k baud.
HC-UIO-2 - refer to Table 6.17 on page 21 to set switches 7 and 8 to communicate at 250k
baud.
Table 6.20 HC-UIO-2 Spare Input / Output Assignments
Board
ID
SW1 Setting
1 2 3 4 5 6
I/O Terminals
1 2 3 4 5 6 7 8
I/O Terminals
9 10 11 12 13 14 15 16
32 Off Off Off Off Off On Configurable Spare Inputs (CONFIG
1>CONFIGURE SPARE INPUTS
Configurable Spare Outputs (CONFIG 1>
CONFIGURE SPARE OUTPUTS
33 On Off Off Off Off On
*34 Off On Off Off Off On
*35 On On Off Off Off On
36 Off Off On Off Off On
37 On Off On Off Off OnDedicated Card Reader Inputs Dedicated Card Reader Inputs
38 Off On On Off Off On
39 On On On Off Off On
40 Off Off Off On Off On
41 On Off Off On Off On
42 Off On Off On Off On
43 On On Off On Off On
44 Off Off On On Off On
45 On Off On On Off On
46 Off On On On Off On
47 On On On On Off On
48 Off Off Off Off On On
49 On Off Off Off On On
50 Off On Off Off On On
51 On On Off Off On On
52 Off Off On Off On On
53 On Off On Off On On
54 Off On On Off On On
55 On On On Off On On
56 Off Off Off On On On
57 On Off Off On On On
58 Off On Off On On On
59 On On Off On On On
60 Off Off On
On On On
61 On Off On On On On
62 Off On On On On On
63 On On On On On On
To Next Page
Loading...
