Nordson EFD E2V - Appendix A, Command Function Reference (continued); Fill Area Command

www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
EV Series Automated Dispensing Systems
73
Fill Area: 1. Rectangle (S path)
This command lls the dened area by passing the tip back and forth along the X axis (in an S-shaped path) at the specied Band
distance while moving the Y axis the specied Width distance after each pass along the X axis. After entering a Fill Area Rectangle
command, enter a Line Start point at the top left corner of the area to be lled and a Line End point at the bottom right corner of
that area.
Line Start
Line End
Fill Area
EXAMPLE: if a Width of 5 mm is entered, the tip makes the following path:
Width = 5 mm
Fill Area
Click Function
Fills a dened area in a specic way using the specied Width and Band parameters. Refer to the explanations
below this table for an example of each Fill Area type.
Parameter Description (see illustration examples)
Type (see below for an
example of each)
1. Rectangle (S path)
2. Circle
3. Rectangle
4. Rectangle Band
5. Circle Band
6. Rectangle (inner to outer)
7. Circle (inner to outer)
Width The distance (in mm) between the center of the bead being dispensed and the bead that
spirals next to it.
Band The width (in mm) the completed ll must be (from one end to the other).
Appendix A, Command Function Reference
(continued)