158 System configuration
10 Enter the route number you configured previously and the route
member, for example 6 1, for RTMB.
11 Select WNK both STRI/STRO and 1 for CHID.
12 Enter a terminal number (tn) for TN, for example 96 0 0 0.
Refer to the superloop configured previously in this procedure.
Note: TN format: L s cu, where L = virtual superloop, s =
shelf, c = card, and u = unit.
13 Click Edit to configure Class of Service (CLS).
14 Select Digitone Dial Pulse (DTDP) for Dial Pulse.
15 Click Return Class of Service.
16 Select Advanced Trunk Configurations and select the check
box for Answer and disconnect Supervision required (SUPN).
17 Click Save.
--End--
Configuring network access
To configure network access using Element manager, follow the steps in
the next procedure.
Procedure 65
Configuring network access
Step Action
1 Select Dialing & Numbering Plans > Electronic Switched
Network from the menu list.
2 Select Customer X > Network Control & Service > Network
Control Parameters (NCTL) > Network Control Basic
Parameters and click Edit.
3 Click Submit.
--End--
Creating ESN control block
If the ESN control block is not configured, complete the following
procedure to create an ESN control block using Element manager.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
