Troubleshooting 235
4. CDP – Trunk Steering code (RLI B is entered, FLEN is equal to
sum of the digits in TSC and DN). See Procedure 70 “Adding Trunk
Steering Code (CDP)” (page 160) for details.
5.
PCA is on and UEXT is configured as follows:
— UXTY SIPN
— KEY 0 SCR <DN>
— KEY 1 HOT P <number of digits> <AC><LOC><DN> (if UDP)
OR
KEY 1 HOT P <number of digits> <TSC><DN> (if CDP)
where DN is the local number of the DECT handset subscribed in
the DAP Manager. See “Call server configuration” (page 170) for
details.
• SIP GW setting - Primary Proxy or Redirect (TLAN) IP address =
NRS IP address
See Procedure 71 “Configuring the signaling server” (page 161) for
details.
•
Signaling Server – the check box for Enable SIP Proxy / Redirect
Server is checked when SIP Gateway and Redirect Server (NRS) are
co-resident Signaling Server – SIP Domain name = domain name
configured in IP DECT Configurator.
See Procedure 72 “Configuring SIP properties” (page 162) for details.
•
Service domain name is the same as SIP domain, configured on the
signaling server and the IP DECT Configurator.
See Procedure 75 “Creating service domain” (page 165) for details.
•
UDP and CDP domains are configured correctly.
See Procedure 76 “Adding the UDP domain” (page 165) and
Procedure 77 “Adding the CDP domain” (page 165) for details.
• Gateway endpoints for DAP and the signaling server are created.
See Procedure 78 “Adding Gateway Endpoint for the signaling server ”
(page 166) for details.
• Routing entries for UDP or CDP (equal to LOC or TSC) are added for
Gateway endpoint for DAP.
See Procedure 79 “Adding Gateway Endpoint for DAP redirect server”
(page 167) for details.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
