Objet Eden500V - Page 98

Operating & Maintaining the Eden 3-D Printer
7–22 DOC-00500 Rev. F
6. Whenthefollowingscreenappears,openthecover.
Figure 7-27: Wiper Cleaning procedure—steps 7–10
7. Putonthecleaningglove.
8. Usingagenerousamountofcleaningfluidandthecleaningcloth,
removeanymaterialremainingonthewiperandthesurrounding
area.
9. Inspectthewiperblade.
Ifthewiperbladeisscratched,tornorworn,orifyoucannotcleanit
completely,replaceit.
a. Graspitand
pullitupandoutofitsbracket.
b. Insertthenewwiperblade,makingsurethatitisstraightandsecured
wellonbothsides.
10. Inthewizardscreen(“Iswiperclean?”),selecttheconfirmationcheck
box(seefigure 7‐27)andclick
Next.
11. Makesurethatyouhaveremovedalltoolsandcleaningmaterials
fromtheprinter,andclosethecover.
12. Selecttheconfirmationcheckboxesinthewizardscreenandclick
Next.
13. Click
Donetoclosethewizard.