Oki B721

Oki Data CONFIDENTIAL
45487001TH Rev.1
4-18 /
4. Maintenance menus
Item Settings Functions
Admin
Setup
Power Setup Power
Save
Enable
Disable
Sets Enable/Disable of Power Save Mode.
Sleep
Enable
Disable
Sets Enable/Disable of Sleep Mode.
Auto
Power Off
Enable
Auto Config
Disable
Set the behavior of Auto Power Off.
Disable: Invalidate to go Off mode by time.
Auto Config: The printer does not go to Off
mode when LAN cable is connected, goes
to Off mode when USB or Centro cable is
connected.
Enable: The printer goes to Off mode even
if LAN cable is connected.
Others
Setup
RAM
Setup
Receive
Buffer Size
Auto
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Sets the size of receive buffer
Resource
Save
Auto
Off
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Sets the size of resource saving area.
This Menu is valid when PCL and other
PDL emulations except PCL are enabled.
Flash
Memory
Setup
Initialize Execute Initializes Resident FLASH.
HDD
Setup
Initialize Execute This category is displayed only if a an
HDD is installed.
The data stored in the HDD needs to be
deleted.The re-initialization of the partition
is not to be executed.
Item Settings Functions
Admin
Setup
Others
Setup
HDD
Setup
Resize
Partition
PCL nn% nn% Specifies the size of partition.
Specifies a size by ratio to the whole HDD
in % (1% unit) .
nn,mm,ll: 1 - 98 and nn+mm+ll=100
(Default values are nn=20, mm=50, II=30.)
Common
mm%
mm%
PS ll% ll%
<Apply>
Format Partition PCL
Common
PS
Formats a specified partition.
Erase HDD Execute This item appears only when HDD is
installed.
It features of the deletion of all the data
stored in the HDD not to be recovered
them. It aimes at the complete deletion of
printing and individual data left in the HDD
by disposal of the printer and clear data at
return. The printer restart after changing
set-up after menu.
Storage
Common
Setup
Check
File
System
Execute Resolves mismatch between actual
memory and displayed memory
available in a file system and performs
administration data (FAT information)
recovery. Performs these by file system. Its
takes several tens of seconds to complete
the job of this function. HDD: Performs
recovery only for an HDD.
Check
All
Sectors
Execute Performs recovery of a defective HDD
sector information and a file system
mismatch mentioned above. The objective
device is only an HDD and it takes 30 to
40 minutes to completed this function for
an HDD of 10GB.
Enable
Initializat-
ion
No
Ye s
Prevents a setting change accompanying
initialization of BlockDeveice(HDD,FLASH).
Security
Setup
Job
Limitation
Off
Encrypted Job
Job limitation mode control.
Jobs other than specified ones (Currently,
only encrypted authentication print can be
specified.) are rejected.