n 3-11 Audio Recording
Sound Recording Options (Movie K)
Adjust settings for recording sound during fi lming. You can also access settings for
use when an external microphone or recorder is connected.
Recording Volume
Adjust microphone sensitivity. Choose separate values for the built-in
and external microphones.
[Built-In K]:
Adjust the sensitivity of the built-in microphone.
[MIC K]:
Adjust the sensitivity of external microphones connected to
the microphone jack.
K Volume Limiter
Choose the maximum volume at which the camera will record sound.
Use this option to automatically reduce the level of sounds above a
certain volume.
Wind Noise
Reduction
Reduce wind noise during audio recording.
Recording Rate
Choose an audio recording format.
[96kHz/24bit]: High-quality audio.
[48kHz/16bit]: Standard-quality audio.
K Plug-in Power
Adjust settings for use with condenser microphones and other devices
that draw power from the camera.
[Off]: For devices that do not require power from the camera (general-
purpose dynamic microphones).
[On]: For devices that require power from the camera (condenser
microphones).
PCM Recorder K
Link
Adjust settings for use with external IC recorders. Record a slate tone
or choose whether camera controls can be used to start and stop
recording when using an Olympus LS-100 IC recorder.
[Camera Rec. Volume]: Choose [Operative] to record sound at the
level selected with the camera, [Inoperative]
to record sound at the level selected with the
recorder.
[Slate Tone]: Enable or disable slate tone recording.
[Synchronized R Rec.]:
Choose whether audio recording begins and
ends at the same time as movie recording.
Headphone Volume Adjust the volume of audio output to the headphones.
• Sounds made by the lens or camera controls may be recorded during fi lming. For reduced
noise, select [S-AF], [MF], or [PreMF] for [n AF Mode] (P. 345) and use camera controls
as little as possible.
• Sound is not recorded:
with high-speed or slow- or fast-motion movies or when k (diorama) is selected for
picture mode.
• O is displayed when [Off] is selected.
• Audio can only be played on devices that support the option selected for [Recording Rate].
413
EN
3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
