184
Programming Console Operations Section 4-2
4-2-30 Reading and Setting the Clock
This operation is used to read or set the CPU’s clock. The clock can be read in
any mode, but can be set in MONITOR or PROGRAM mode only.
1,2,3... 1. Press the CLR Key to bring up the initial display.
2. Press the FUN Key, SHIFT Key, and then the MONTR Key to display the
date and time.
3. Press the CHG Key to change the date and/or time.
The digit that can be changed will flash. If necessary, input a new value
with the Up and Down Arrow Keys or Numeric Keys. Press the CHG Key
to move the cursor to the next digit. The following table shows the setting
ranges for each value.
4. Press the WRITE Key to write the new value.
Press the CLR Key to return to the initial display.
Operation RUN MONITOR PROGRAM
Read clock OK OK OK
Set clock No OK OK
Year Month Day Hour Minute Second Day-of-week
00 to 99 01 to 12 01 to 31 00 to 23 00 to 59 00 to 59 0 to 6
(SUN to SAT)
FUN
SHIFT
MONTR
TIM 99-02-22
11:04:32 MON(1)
CHG
TIM CHG?~9-02-22
11:04:32 MON(1)
WRITE
INST TBL READ
FUN018:HEX
To Next Page
Loading...
Need help?
General
