302
Revision Histoy
05 April 2002 Specifications were changed to update to CPM2C-CIF01-V1 Peripheral/RS-232C Adapter Unit. Spe-
cific changes are as follows:
Page 4: Last line on page removed.
Pages 6, 12, 13, 32, 76, 139, 142 to 144, 160, 161, 218, 222, 224, 280, and 283: Graphics and model
numbers (-V1 added) changed.
Pages 52, 54 to 56, 60, 61, 63 to 67, and 108 to 110: “COM ( )” changed to “COM (-) or “-” added to
diagram.
Page 72: Table added.
Pages 73, 183, 161, and 237: Notes added.
Page 75: Information added on SW1.
Page 229: Digital Controller Board added.
Page 231: Read data area and write data area corrected at bottom of page.
Page 244: Description of bits 12 to 15 at bottom of page altered.
Page 255: “Read” added in table at bottom of page.
Page 266: DM 0013 corrected (including setting of bits 9 to 11).
Page 275: Cable added.
06 November 2004 Minor changes and corrections to information were made, and Appendix D was created from informa-
tion in Section 4. Specific changes are as follows:
Page xiii: Safety precaution added.
Pages xvi and xvii: Standard changed from EN50081-2 to EN61000-6-4.
Page 2: Information on sharing Programming Devices changed.
Pages 12, 75, 275, and 280: Diagram showing Peripheral/RS-232C Adapter Unit changed.
Page 23: Optional battery backup lifetime changed from 2 to 5 years.
Page 30: Lot number 31800 changed to 3180O in note.
Pages 40 and 43: Numbers added to outputs in diagram.
Pages 54, 55, 56, 64, 65, 107, 131, and 132: Note added.
Page 95: Diagram showing connectors changed.
Page 114: Diagram added.
Page 133: Applicable cable model changed for G70D-SOC16-1 and G70D-FOM16-1 Relay Terminals.
Pages 139 to 140: Information removed and new information on CX-Programmer connections added.
Page 144: Note changed.
Pages 147 to 159: Information on SYSMAC-CPT and SYSMAC Support Software removed from Sec-
tion 4 and most of this information moved to Appendix D (new).
Page 168: Functions added to table.
Page 170: Information on new operations added.
Page 193: “C” changed to “CNT” and “T” changed to “TIM” in Data column of table.
Page 215: Information on battery replacement changed.
Page 219: “-15PC” suffix added to ATMEL model number for EEPROM.
Page 228: Table added.
Page 231: “Starting address of separate area” added to end of control data area table.
Pages 251 and 253: Meaning of FF16 error code changed and corresponding note added.
Page 274: SYSMAC-CPT and SYSMAC Support Software removed from table.
Page 278: Diagrams changed.
Page 292: Appendix D added.
07 September 2005 Page v: Information on general precautions notation added.
Page xi: Information on liability and warranty added.
08 February 2008 Page 4: Change number of mountable Analog I/O Units to 3 and added note.
Pages 5, 116, and 117: Added note.
Page 91: Added recommended Screwdriver to top table.
Page 137: Added sentence to bottom of page.
Page 138: Remove last heading and paragraph from page.
Revision code Date Revised content
To Previous Page
Loading...
