MicroHAWK Engine Integration Guide 1-35
Quick Start
User Access Levels
When password protection is enabled, AutoVISION provides four levels of access:
Operator:
An Operator can monitor the Run view of AutoVISION, but cannot access other screens
or change settings.
Supervisor:
A Supervisor can switch to Edit mode and adjust ROI (region of interest) positions, retrain
tools, change the selected device, save the current job, or load a different job. A Supervisor
cannot modify the parameters of the current job or add or remove tools.
Engineer:
An Engineer has full access to all settings and is only restricted from changing passwords.
Administrator:
An Administrator has full access to all settings, and can change the passwords for all
access levels.
Changing the Access Level
When password protection is enabled, AutoVISION will always start with the access level set
to
Operator
, which blocks access to the
Connect
,
Image
, and
Edit
views. You can change
the access level by clicking the icon shown below and entering as an
Administrator
.
Your current access level is always displayed in text below the icon. Click the icon to display
the following dialog:
This dialog provides a button for each of the four access levels. The highlighted button shows
the current access level. In the example above, the current access level is
Administrator
.
To Next Page
Loading...
