Omron SYSDRIVE 3G3MV - Page 76

3-8
Note 1.Thesettingunitofthefrequencyreferenceandoutputfrequencyisdetermined
by the set value in n035. The default unit is Hz.
Note 2. The output power monitor is not displayed in vector control mode. ’--------’ is
displayed instead
Note 3. This function is provided for 200-- and 400--V (5.5/7.5kW) inverters only.
H Example of Forward/Reverse Selection Settings
Key
sequence
Indicator Display
example
Explanation
Press the Mode Key repeatedly until the F/R
indicator is lit.
The present setting will be displayed.
For: Forward; rEv: Reverse
Use the Increment or Decrement Key to
change the direction of motor rotation. The
direction of motor rotation selected will be
enabled when the display changes after the
key is pressed.
Note The direction of motor rotation can be changed, even during operation.
H Example of Local/Remote Selection Settings
Key
sequence
Indicator Display
example
Explanation
Press the Mode Key repeatedly until the
LO/RE indicator is lit.
The present setting will be displayed.
rE: Remote; Lo: Local
Use the Increment or Decrement Key to set
the Inverter to local or remote mode. The
selection will be enabled when the display
changes after the key is pressed.
Preparing for Operation and Monitoring Chapter 3