Omron WS02-SIMC1-E - V1.9 REV 02-2009 - Page 14

xvi
• Functions Supported for Unit Version 3.0 or Later
The following tables list the functions added for unit version 3.0 and supported
by the CX-Programmer. CX-Programmer version 5.0 or higher and
CX-Simulator version 1.5 or higher are required to use these functions.
CS1-H CPU Units
CS1@-CPU@@H
Function
Unit version 3.0 or
later
Other unit versions
Function blocks OK ---
Serial Gateway (converting FINS commands to CompoWay/F
commands at the built-in serial port)
OK ---
Comment memory (in internal flash memory) OK ---
Expanded simple backup data
TXDU(256), RXDU(255) (support no-protocol
communications with Serial Communications
Units with unit version 1.2 or later)
OK ---
Model conversion instructions: XFERC(565),
DISTC(566), COLLC(567), MOVBC(568),
BCNTC(621)
OK ---
New application
instructions
Special function block instructions: GETID(286) OK ---
Additional in-
struction func-
tions
TXD(235) and RXD(236) instructions (support
no-protocol communications with Serial Commu-
nications Boards with unit version 1.2 or later)
OK ---
CS1D CPU Units
Unit version 3.0 is not supported.
CJ1-H/CJ1M CPU Units
CJ1@-CPU@@H
CJ1G-CPU@@P
CJ1M-CPU@@
Function
Unit version 3.0 or
later
Other unit versions
Function blocks
OK ---
Serial Gateway (converting FINS commands to CompoWay/F
commands at the built-in serial port)
OK ---
Comment memory (in internal flash memory)
OK ---
Expanded simple backup data
OK ---
TXDU(256), RXDU(255) (support no-protocol
communications with Serial Communications
Units with unit version 1.2 or later)
OK ---
Model conversion instructions: XFERC(565),
DISTC(566), COLLC(567), MOVBC(568),
BCNTC(621)
OK ---
New applica-
tion instruc-
tions
Special function block instructions: GETID(286)
OK ---
Additional in-
struction func-
tions
PRV(881) and PRV2(883) instructions: Added
high-frequency calculation methods for calculat-
ing pulse frequency. (CJ1M CPU Units only)
OK ---