Performing Initial Configuration (CLI)
Configure Networking. Configure the appliance network interfaces. The first
network interface has been configured for you, using the settings you provided
at the serial console.
Subcommands that are valid in this context:
datalinks => Manage datalinks
devices => Manage devices
interfaces => Manage interfaces
help [topic] => Get context-sensitive help. If [topic] is specified,
it must be one of "builtins", "commands", "general",
"help" or "script".
show => Show information pertinent to the current context
abort => Abort this task (potentially resulting in a
misconfigured system)
done => Finish operating on "net"
hostname:maintenance system setup net> devices show
Devices:
DEVICE UP MAC SPEED
igb0 true 0:14:4f:8d:59:aa 1000 Mbit/s
igb1 false 0:14:4f:8d:59:ab 0 Mbit/s
igb2 false 0:14:4f:8d:59:ac 0 Mbit/s
igb3 false 0:14:4f:8d:59:ad 0 Mbit/s
hostname:maintenance system setup net> datalinks show
Datalinks:
DATALINK CLASS LINKS LABEL
igb0 device igb0 Untitled Datalink
hostname:maintenance system setup net> interfaces show
Interfaces:
INTERFACE STATE CLASS LINKS ADDRS LABEL
igb0 up ip igb0 192.168.2.80/22 Untitled Interface
hostname:maintenance system setup net> done
To create a management interface now, use the following steps as an example:
Configuring the Appliance for the First Time 257
To Next Page
Loading...
Need help?
General
