13
3.2 Storage
If B500/B500-S power wheelchair is not moved for several days, permanent colour changes may oc-
cur where the wheelchair comes into contact with the surface it is standing on. This is why Otto Bock
recommends storage on a suitable surface during extended periods of disuse.
The B500/B500-S power wheelchair must be stored in an enclosed room. Remove the main fuse;
otherwise, there is a risk of deep discharge.
The storage location must be dry and have sufcient air circulation. There must not be any build-up
of humidity. The B500/B500-S power wheelchair must not be subjected to any damaging exterior
inuences, e.g. rain, snow or strong solar radiation during storage.
Otto Bock recommends storing the
B500/B500-S
power wheelchair with slightly elevated tyre
pressure and to use assembly stands or wooden blocks in order to raise the tyres (completely)
off the ground in order to protect them from frost. Regularly rotating the wheels helps to prevent
at spots.
Suitable tools and accessories for the completion of service tasks are listed below:
❒ Flathead screwdriver, blade widths: 2.5/3.5/5.5 mm
❒ Phillips head screwdriver, size: 2
❒ Reversible ratchet handle wrench and sockets, sizes: 8 – 20
❒ Ring or combination wrenches, sizes: 8 – 24
❒ Allen wrenches, sizes 2, 3, 4, 5, 6, 7, 8
❒ Torque wrench
❒ Socket, size 19
❒ Puller
❒ Pin punch, Ø 3 mm
❒ Plastic hammer
❒ Drill bit, size 4/6 mm + hand drill
❒ Plastic tyre mounting lever
❒ Inner tube repair kit
❒ Side cutting pliers
❒ Water pump pliers, gripping width up to 32 mm
❒ Liquid thread lock “medium strength”
❒ Handheld programming device
To Next Page
Loading...