49
1
2
1 Seat cushion
2 Seat plate
NOTICE
Ensure the cables attached to the frame with cable ties are not damaged.
Changing the seat height of the B500/B500-S power wheelchair requires replacement of the
seat brackets. At the front, the seat brackets are screwed directly to the frame.
❒ Remove the seat.
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
1. Remove the black plastic caps of the rear Allen head screws.
2. Loosen the Allen head screws on the rear seat brackets.
3. Loosen the Allen head screws on the two front seat brackets.
4. Remove the seat brackets from the seat frame and replace if required.
Properly reassemble all components upon completion of the work.
To Next Page
Loading...