62
5. Connect the additional cable to the controller.
6. Install the seat back on the bearing plate (see Section 6.10.1).
7. Fully assemble the seat with side panels, footrests etc.
8. Program the control unit.
(Option)
The electric footrests are delivered as a preassembled unit (knee pads optional). The footrests
of the B500/B500-S power wheelchair are self-contacting.
❒ Remove the standard footrests and footrest adapters.
❒ Allen wrench, size 5 mm
❒ Ring or open-end wrench, size 13
To Next Page
Loading...