22
Green LED ashes 1x
2x
permanently
Low-maintenance battery
Maintenance free (GEL) battery
Battery charged to 80 %
Yellow LED is lit Battery is charging
Green LED is lit Battery is fully charged
Red LED is lit Battery is defective or missing, or charging time has been exceeded
The battery charger features a programmed recharging phase. Once a discharged battery is
completely charged (after approximately 8 hours), the battery charger can remain connected
with no risk of overcharging or damaging the battery.
. Always remove the main fuse before doing any work on the
batteries.
NOTICE
Ensure correct polarity is used when connecting the batteries.
❒ Remove the battery cover (see Section 6.3.1).
❒ Remove the fuse (see Section 6.2).
❒ Open-end or combination wrench, size 11
1. Disconnect all battery cables. Lift out the batteries by the handles and replace if required.
Properly reassemble all components upon completion of the work.
NOTICE
Ensure correct polarity is used when connecting the batteries.
❒ Remove the battery cover (see Section 6.3.1).
❒ Remove the fuse (see Section 6.2).
❒ Remove the battery (see Section 6.3.3).
To Next Page
Loading...