78
The three parameters in the “Hand controls” menu refer to the hand control device and attend-
ant controls. This menu is followed by four sub-menus that refer to the following control devices:
Speed Mode, Joystick, Sound & Display and Charger.
Auto Shutoff 0 – 60 min
After this period of inactivity, the power wheelchair is automatically
turned off. A value of 0 deactivates this function.
Key Lock
Function
0, 1, 2
Establishes how a locked system can be reactivated. A value of 0
deactivates this function.
Push and hold the On/Off button on one of the two control devices
for at least 2 seconds. When the button is released, the system shuts
off and the drive-away lock is activated.
Cancelling the drive-away lock depends on the setting of the Key
Lock Function parameter.
When it is set to 1, you have to press the horn button during the activa-
tion test of the LCD. (The regular sound of the horn is replaced by a
short beep.) If this process was not completed successfully, only the
key symbol is shown on the display after the activation test is complete
in order to indicate that the drive-away lock is still active. In order to
cancel the drive-away lock, you have to turn off the system and carry
out the start-up sequence again.
If the parameter is set to 2, you have to move the joystick as follows
during the activation test of the LCD: Push the joystick forward until
you hear a beep, then backward until you hear a beep and nally to
the centre until you hear a beep. If this process was not completed
successfully, only the key symbol is shown on the display after the
activation test is complete in order to indicate that the drive-away lock
is still active. In order to cancel the drive-away lock, you have to turn
off the system and carry out the start-up sequence again.
Attendant
Takeover
1, 2
Determines if the hand controller can turn off the system when the
attendant control unit is active.
When the parameter is set to 1, the attendant control unit is the master
and the hand controller cannot turn off the system.
When the parameter is set to 2, the hand controller can turn off the
system even if the attendant control unit is turned on.
To Next Page
Loading...