Otto B500 - 7.3.1 Configuration Parameter

74
The enAble40 wheelchair control features a number of parameters that may be programmed
using the hand programming device or 1314 PC programmer. These programmable parameters
allow the driving characteristics and performance of the vehicle to be adapted to special deploy-
ment requirements. Information about the use of the hand programming device can be found in
Section 7.4.1.
The controller for the enAble40 control unit contains four complete datasets for all programmable
parameters. This allows the specialist dealer to stock a controller with four congurations that
match up to four different wheelchair models. The “Conguration” parameter determines which
of these four congurations is active.
 
When the “Conguration” parameter is changed, Powerbase stores the parameters of this con-
guration but the hand programming device does not. This is why you should disconnect and
then reconnect the hand programming device after changing the “Conguration” parameter,
so that the hand programming device can download the new settings. The hand programming
device only stores the data it downloads when it gets connected.