55
(Option for Recaro® Seat Only)
❒ Screwdriver
❒ Allen wrench, size 4
❒ Hand drill
❒ Drill bit, size 4
1. Screw the cross tube to the back of the seat frame (see Figure 50-1).
2. Attach the single strap end to this tube (see Figure 50-2):
– Spread the two eyelets so they t over this tube.
–
Insert the screw through the eyelets and bore hole in the centre of the tube and tighten the
screw.
3. Remove the protective cap from the button (see Figure 50-3).
4. Remove the back adjustment button from the back rest (see Figure 50-4).
5. Press out the three small plastic nipples from the rear (see Figure 50-5).
6. Remove the rest of the covering.
7. Of the two holes in the metal plate, bore out the top hole (for the strap mounting screws) (see
Figure 50-6).
8. Attach both of the other strap ends to these bore holes.
9. Install the covering and adjustment button.
To Next Page
Loading...