Otto B500 - 7.3.2 MyChair Parameter

75
 


Conguration 1 – 4
Powerbase stores up to four conguration datasets or congurations.
This parameter is used to select the active conguration.


 The enAble40 wheelchair control included in the scope
of delivery is precongured by Otto Bock. Incorrect selection of the
“Conguration” parameter can lead to uncontrollable operating per-
formance with a risk of accidents.
Ensure that you have selected the correct conguration for your
wheelchair model:
– Parameter 1 = A200
– Parameter 2 = B500 6 km/h
– Parameter 3 = B500-S/B500-S 10 km/h
– Parameter 4 = Skippi
 
 
The “MyChair” parameter allows the selection of Prole 1, Prole 2, or a blend of the proles
with settings that lie between the two proles.
Parameter Allowable
Range
Description
MyChair 1.0 – 2.0 A setting of 1.0 selects Prole 1; a setting of 2.0 selects Prole 2. All
other settings (1.1 – 1.9) select a blend or interpolation between the
individual parameters in Prole 1 and 2.
 
 Characterised by the settings in the Drive and Steer menus of Prole 1.
Characterised by the settings in the Drive and Steer menus of Prole 2.
The settings in Prole 2 are more “aggressive” than the settings in Prole 1.
The Drive and Steer menus of the two proles allow the OEM to programme two different driving
and steering characteristics for each conguration: This results in 8 combinations (4 congura-
tions x 2 proles). In practice, this means that many additional wheelchair characteristics are
instantly available under these two parameters alone (Conguration and MyChair), since each
prole can be set to each of the eleven points in the prole adjustment range. This results in
tremendous exibility without the need to change any other parameters.