65
Some components, e.g. the batteries, frame, seat and
motors, are very heavy. When removing or installing such components, ensure they are lifted in an
ergonomically correct manner. Hoisting devices of sufcient capacity must be used where applicable.
❒ Allen wrench, size 5
❒ Allen wrench, size 6
1. Remove the seat including seat frame.
2. Remove the lights.
3. Remove all components attached to the frame and drive unit sustainer:
– Battery case (see Section 6.3.4)
– Controller (see Section 6.4)
– Side panels (see Section 6.5)
– Footrests (see Section 6.6)
– Wheels (see Section 6.7)
– Brake release (see Section 6.8.1)
– Motors (see Section 6.16)
– Anti-tipper (see Section 6.17)
– Bumper bar (see Section 6.19.6)
Properly reassemble all components upon completion of the work.
Static electricity caused by factors such as friction may lead to electrostatic discharge
(high voltage with low current) upon contact with the wheelchair; however, this does not represent
a health hazard. Since this may impair comfort, it can be prevented by mounting a ground strap
on the drive unit sustainer / wheelchair frame.
To Next Page
Loading...