Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
98
25.11 Disable / re-enable alert annunciation
function (H2/B11)
Normal operation:
For alarm points / zones programmed for Alert Annunciation (via
EBLWin) is normally the AA function enabled via a time channel, e.g.
enabled daytime (during working hours) and disabled night time.
As an alternative, the AA function can be continuously enabled.
Turned Off
Via this menu (H2/B11) it is possible to disable the AA function, i.e.
the AA function will be disabled for the alarm points / zones
programmed for Alert Annunciation in spite of the time channel is
"on" or if they are programmed to be continuously enabled.
The AA function will stay disabled until re-enabled again via this
menu.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H2.
Disable or re-enable
ACCEPT? H2
"A"
Disable zone
ACCEPT? B1
Scroll to menu B11.
Disable / re-enable alert annunciation
function ACCEPT? B11
"A"
Alert annunciation function is in normal
operation. Press ACCEPT to turn off
Depending on the actual
status one of the texts will
be shown.
"A"
Alert annunciation function turned off.
Press ACCEPT to set to normal
"Return"
Disable / re-enable alert annunciation
function ACCEPT? B11
Scroll or press "Return" to
menu H2.
"Return"
Disable or re-enable
ACCEPT? H2
Scroll or press "Return".
NOTE! Disabled Alert Annunciation function is not indicated by
LED "Disablements" (L8).
The LED "Fault / Disablements Fire brigade tx delay" (L16) turned
off, is indicating that the Alert Annunciation function is turned off by
a time channel or is disabled via this menu.