Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
83
24 Perform monthly test (H1)
EBL128 and the installation shall be tested on a regular basis. If one
twelfth of the alarm points are tested each month, the whole
installation will be tested after one year. In test mode, only the alarm
points are tested, i.e. no outputs (no sounders) will be activated during
the test. (Alarm devices can be tested via menu H8/S6.)
If a real fire alarm is activated by an alarm point not in test mode,
the normal fire alarm functions will be activated, i.e. fire alarm
presentation, outputs (sounders) activated, routing equipment (fire
brigade tx) activated, etc. but the zone(s) in test mode will remain in
test mode until the test mode is ended. During the fire alarm the
zone(s) in test mode can be displayed via menu X3, see chapter
"Display disablements (X3)", page 47.
See also chapter "The display in EBL128", page 21.
NOTE! If the EBL128 door is left open, the output(s) for routing
equipment (fire brigade tx) might be disabled (if set so in EBLWin).
There will be an automatic ending of the test mode one hour after the
latest tested alarm point / zone.
See also chapter "Perform ZONE TEST (test mode) (H7)", page 124.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Perform monthly test
ACCEPT? H1
"A"
Check that all LEDs light up!
ACCEPT
"A"
▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒
▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒ ▒
The buzzer (in EBL128)
sounds and all dots in the
display are shown. All
LED:s light up, incl.
LED:s in units connected
via I/O Matrix board 4582.
"A"
Zones to be set in test mode:
?? ?? ?? ?? Start test: ACCEPT
Write zone numbers
(e.g. 01, 02, 03, 04)
Zones to be set in test mode:
01 02 03 04 Start test: ACCEPT
Press "A" to start the test
mode.
"A"
Zones in test mode:
01 02 03 04 End test: ACCEPT
LED "Test mode" (L9)
will light up. Perform the
tests.