Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
81
23 Access
To use the key pad in EBL128 (to get access to the menu tree), it is
necessary to log in with a User name and Password for level 2B, 2C or
3A.
See also chapter "User level, User name & Password", page 23.
Open the EBL128 door (= level 2A), press the "Access" button (P8)
and continue as follows:
Explanations, to the table column headings:
68
0: Information only (level 2B), 1: Building officer (level 2C) and 2:
Service personnel (level 3A) are default in EBLWin. For safety reasons they
are recommended to be changed and others to be added, i.e. after SSD
download there might be up to ten (0-9) log in alternatives available.
Action
Text in display
Comments
"Access"
Log in as:
0: Information only ->
Before SSD download
only "0" is required to log
in and get access to all the
menus.
After SSD download the
settings done via EBLWin
will be valid, i.e. up to ten
(0-9) log in alternatives
might be available.
68
:
Step with -> to the
wanted alternative and
press "A"
or
press "0", "1", … "8" or
"9" and "A"
Password: 
The digits are replaced
() in the display.
NO ACCESS!
Wrong password was
entered. Try again.
NOTE! After three wrong
passwords the log in
function will be blocked
for one hour for the user
name respectively.
Perform monthly test
ACCEPT? H1
Correct password was
entered. Menu H1 is
shown. Press "A" to accept
(i.e. to perform a monthly
test) or scroll / jump to
another menu (H2-H10).