Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
114
28.2 Sensitive fault detection mode (H5/A2)
"Sensitive fault detection mode" means that the normal time delays for
all type of faults are reduced, which makes it possible to find faults
during the commissioning instead of later.
This mode is indicated by the LED "Fault tx activated" (L11).
NOTE 1! The "Fault" output for routing equipment is also
"activated".
NOTE 2! Don't forget to turn this mode off after the commissioning.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H5.
Service
ACCEPT? H5
"A"
Calibration of supervised outputs
ACCEPT? A1
Scroll to menu A2
Sensitive fault detection mode
ACCEPT? A2
"A"
Sensitive fault detection mode is
not active. Press ACCEPT to activate
Depending on the actual
status one of the texts will be
shown.
Press "A" to accept or press
"Return" to menu A2.
Sensitive fault detection mode is active
Press ACCEPT to deactivate
"Return"
Sensitive fault detection mode
ACCEPT? A2
Scroll or press "Return" to
H5.
"Return"
Service
ACCEPT? H5
Scroll or press "Return".
NOTE! Don't forget to turn this mode off after the commissioning.