Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
88
25.3 Disable output (H2/B3)
Up to 100 Control outputs, except outputs of type "alarm device",
can be individually disabled. Disabled output will stay in (or return
to) the normal condition for the output respectively.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H2.
Disable or re-enable
ACCEPT? H2
"A"
Disable zone
ACCEPT? B1
Scroll to menu B3.
Disable output
ACCEPT? B3
"A"
Disable output type: 0
0=Loopunit 1=S 2=R0 3=EXPB ACCEPT?
Press:
"0"=3361 or 3377/4477
or 3379 or 3364 or 4380
or 4383
"1"=C.i.e. output S0-S1
"2"=C.i.e. output R0
"3"=C.i.e. exp. board
output.
72
Press "A" to accept.
"0", "1", "2" or "3"
"A"
Depending on the
chosen type the
following will be
shown:
Disable output 0 technical address 000
ACCEPT?
Disable S0
ACCEPT?
Disable R0
ACCEPT?
Disable output 0 expansion board 0
ACCEPT?
Regarding the 3377/4477
& 3379 units' output no.:
0=high priority
1=medium priority
2=low priority
Write the data.
Press "A" to accept.
LED "Disablements"
(L8) will light up.
(Type 2 chosen.)
"A"
Output R0 disabled
"A"
Disable R0
ACCEPT?
"Return"
Disable output type: 0
0=Loop unit 1=S 2=R0 3=EXPB ACCEPT?
If more disablements
shall be done, continue
72
Expansion board (EXPB) 0-3,
4581: Relay output 0-7 alt. 4583: Output 0-2.