Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
120
28.7 Activate address setting mode for DU
(H5/A7)
This function can be used by commissioning / service engineer to
activate the address setting mode in the following Display Units
connected to the RS485 interface in EBL128:
 Ext. Presentation unit (EPU) 1728
 Alert Annunciation unit (AAU) 1735 / 1736
 Ext. Fire Brigade Panel (FBP) 1826 / 1828
A specific unit or all units can be activated for address setting.
NOTE! The units have to be in operation and in quiescent condition,
i.e. the units have to have an address set already.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H5.
Service
ACCEPT? H5
"A"
Calibration of supervised outputs
ACCEPT? A1
Scroll to menu A7
Activate address setting mode for DU
ACCEPT? A7
"A"
Activate address setting mode for DU 0
(9 = All) ACCEPT?
Write the unit's address (0-
7). 9 = All units.
Press "A" to accept.
E.g. "9"
"A"
Operation failed!
If the address setting mode
was not activated.
E.g. "9"
"A"
All DU set in address setting mode
The address has now to be
set / changed in the DU
respectively.
"Return"
Activate address setting mode for DU
ACCEPT? A7
Scroll or press "Return" to
H5.
"Return"
Service
ACCEPT? H5
Scroll or press "Return".