Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
126
31 Maintenance (H8)
Only authorised personnel have access to the level 3A menus. User
name and Password for level 3A (Service Personnel) are required.
Disconnected (disabled) loop, etc. is indicated by LED
"Disablements" (L8) and is listed in menu H4/U1.
31.1 Disconnect / Re-connect COM loop (H8/S1)
To avoid damage on the units and EBL128 during physical connection
/ disconnection of loop units, it is highly recommended to have the
loop disconnected (disabled), i.e. the loop is voltage free (dead).
NOTE! When you disconnect and re-connect the COM loop, all the
statistics shown in menu H5/A6 will be erased and set to "0".
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H8.
Maintenance
ACCEPT? H8
"A"
Disconnect / Re-connect COM loop
ACCEPT? S1
"A"
or
"Return"
COM-loop is connected.
Press ACCEPT to disconnect
Depending on if the COM
loop shall be disconnected
or re-connected, press "A"
or "Return"
"A"
or
"Return"
COM-loop is disconnected.
Press ACCEPT to re-connect
"A"
Disconnect / Re-connect COM loop
ACCEPT? S1
Scroll or press "Return" to
H8.
"Return"
Maintenance
ACCEPT? H8
Scroll or press "Return".