Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
93
25.7 Re-enable output (H2/B7)
Disabled outputs are listed in menu H4/U1.
When all outputs have been re-enabled, the LED "Disablements" (L8)
will be turned OFF, if there are no other disablements.
If there is nothing to re-enable, --- List is empty --- will be
shown.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H2.
Disable or re-enable
ACCEPT? H2
"A"
Disable zone
ACCEPT? B1
Scroll to menu B7.
Re-enable output
ACCEPT? B7
"A"
Re-enable output type: 0
0=Loopunit 1=S 2=R0 3=EXPB ACCEPT?
Only disabled type(s) will
be shown. Press:
"0"=3361 or 3377/4477 or
3379 or 3364 or 4380 or
4383
"1"=C.i.e. output S0-S1
"2"=C.i.e. output R0
"3"=C.i.e. exp. board
output.
73
Press "A" to accept.
Or, e.g. if only type 2 is disabled:
Re-enable output type: 0
2=R0 ACCEPT?
"0", "1", "2" or "3"
"A"
Depending on the
chosen type the
following will be
shown:
Re-enable output 0 technical address 000
ACCEPT? L
Re-enable output S0
ACCEPT? L
Re-enable output R0
ACCEPT? L
Re-enable output 0 expansion board 0
ACCEPT? L
L=A list in which you can
scroll.
Regarding the 3377/4477
& 3379 units' output no.:
0=high priority
1=medium priority
2=low priority
Press "A" to accept.
"A"
--- List is empty ---
All types are re-enabled.
"Return"
Re-enable output
ACCEPT? B7
If more re-enabling shall
be done, continue like
73
Expansion board (EXPB) 0-3,
4581: Relay output 0-7 alt. 4583: Output 0-2.