Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
99
26 Set calendar and clock (H3)
When required, the clock can be corrected, so that the "time stamps"
for fire alarms, faults, etc. will be correct.
The way the date is presented could be different for different
languages.
NOTE! The RTC component has no built-in battery, i.e. if EBL128 is
out of power (no mains and no battery backup) and after new software
has been downloaded, the date, day of the week and the time have to
be set when EBL128 is powered-up again.
NOTE! The information shown in the display will be saved when
you press "A".
Press "Return" instead of "A" to return to menu H3 without any
changes.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H3.
Set calendar and clock
ACCEPT? H3
"A"
Date: 20YY-MM-DD Time: hh:mm:ss
Weekday:1 (1=Monday, 7=Sunday)
The time shown is the time
when "A" was pressed (in
menu H3).
When required, edit the
date, time and/or weekday.
Press "A". The "clock"
starts again from the date,
time, etc. shown in the
display.
NOTE! Press "Return"
(instead of "A") to return
to menu H3 if no changes
are to be done.
NOTE! The date is in some conventions / languages shown
as DD-MM-YYYY.
YY=Year
MM=Month
DD=Date
hh=hour
mm=minute
ss=second
Settings done
"A"
Date and time was set.
Date: 20YY-MM-DD Time: hh:mm:ss Day D
Depending on if "A" or
"Return" is pressed.
Scroll or press "Return".
"Return"
Set calendar and clock
ACCEPT? H3