Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
96
25.9 Disable / re-enable alarm devices (H2/B9)
Disabled alarm devices are listed in menu H4/U1.
Outputs for alarm devices can be collectively disabled and re-enabled
via this menu. Disabled output will stay disabled, until re-enabled
again via this menu.
When all outputs type Alarm devices have been disabled, the LEDs
"Disablements" (L8) and "Fault / Disablements Alarm devices"
(L13) will be turned ON.
When all outputs type Alarm devices have been re-enabled, the LED
"Fault / Disablements Alarm devices" (L13) will be turned OFF.
NOTE! This function for alarm devices is not the same as for push
button "Silence alarm devices" (P3) – unless the option Button
"Silence alarm devices" disables alarm devices, is selected in EBLwin
System properties, see chapter "Silence Alarm devices", page 29.
This menu has higher priority than the push button "Silence alarm
devices".
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H2.
Disable or re-enable
ACCEPT? H2
"A"
Disable zone
ACCEPT? B1
Scroll to menu B9
Disable / re-enable alarm devices
ACCEPT? B9
"A"
Alarm devices in normal condition
Press ACCEPT to disable
Depending on the actual
status one of the texts will
be shown.
"A"
Alarm devices disabled
Press ACCEPT to re-enable
"Return"
Disable or re-enable outputs for
routing equipment ACCEPT? B9
Scroll or press "Return" to
return to H2.
"Return"
Disable or re-enable
ACCEPT? H2
Scroll or press "Return".