Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
30
8.1 Silence alarm devices (inside switch)
NOTE! The functions in this chapter are valid for the New Zealand
convention only.
The button "Silence alarm devices" (P3) is called the "inside switch"
and has the following function:
The inside switch toggles between two states.
 Alarm devices disabled
All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated.
 Alarm devices not disabled
All programmable outputs of type "Alarm devices" enabled,
i.e. they can be activated.
If the inside switch is in its disabled state when the c.i.e. door is being
closed the buzzer will beep once and the message "Silence switch
left active" will be shown in the LCD. For priority order see
chapter "The display in EBL128", page 21.
NOTE! The inside switch has no function if the outside switch (see
below) is activated (ON).
8.2 New Zealand FB Silence switch (outside
switch)
NOTE! The functions in this chapter are valid for the New Zealand
convention only.
The "New Zealand FB Silence switch" is called the "outside switch"
since it is placed outside the c.i.e. The outside switch is a key switch
and connected to a programmable input with the trigger condition
"New Zealand FB Silence switch".
The outside switch can be in two states.
The outside switch is turned ON (i.e. from not activated to activated
state).
 All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated. The "inside switch"
(see above) has no function.
 LEDs "Fire" (on the front) changes from blinking to steady
(continuous).
26
 The c.i.e. built-in buzzer is disabled.
 A fault is generated
27
: "FAULT: FB Silence switch
active".
26
This is valid also if the fire alarm is activated after the outside switch is
turned ON.