Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
129
31.4 Acknowledge SERVICE signal (H8/S4)
See chapter "Sensors activating SERVICE signal (H4/U4)", page 107.
Indicated by LED "Service" (L12), which will be turned off when all
sensors have been acknowledged.
When a sensor (analog smoke detector) that has generated SERVICE
signal is acknowledged, the sensor will be given a default sensor value
as for a new / clean sensor, i.e. first replace the sensor then
acknowledge the service signal as soon as possible.
The very first week average sensor value after the SERVICE signal is
acknowledged will be calculated within one hour. Thereafter a new
week average sensor value will be calculated every week.
NOTE! If a sensor is replaced without activating service signal, it has
to be reset to the default sensor value via menu H8/S5, see page 130.
If there are no sensors having activated SERVICE signal,
--- List is empty --- will be shown.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H8.
Maintenance
ACCEPT? H8
"A"
Disconnect / Re-connect COM loop
ACCEPT? S1
Scroll to menu S4.
Acknowledge SERVICE signal
ACCEPT? S4
"A"
Sensor : xx-xx (technical address xxx)
needs service L
L = a list in which you can
scroll. Press "Fault
acknowledge" to
acknowledge the service
signal or press "Return" to
S4.
"Fault acknowledge"
The service signal for that sensor is now acknowledged and
the next sensor will be shown in the display.
If more service signal
acknowledgements shall
be done, continue like
above. If not, press
"Return" to menu S4.
Sensor : yy-yy (technical address yyy)
needs service L
"Return"
Acknowledge SERVICE signal
ACCEPT? S4
Scroll or press "Return" to
menu H8.
"Return"
Maintenance
ACCEPT? H8
Scroll or press "Return".