Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
117
28.4 Display current consumption in unit
(H5/A4)
Control unit: The total current consumption (incl. the charging
current at 24 V) for the control unit when it is connected to the mains
(230 V AC), i.e. this function is not working by battery backaup.
NOTE! No or very small current consumption will not be presented
correctly / precisely since the accuracy is ± 5 mA.
Charging: The battery charging current.
Low capacity voltage difference: During the battery capacity check
the voltage is measured with and without a resistor. A difference
between these two voltages > 2100 mV will result in a "Low battery
capacity" fault. This is checked every 4
th
hour.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 81.
Scroll to menu H5.
Service
ACCEPT? H5
"A"
Calibration of supervised outputs
ACCEPT? A1
Scroll to menu A4
Display current consumption in unit
ACCEPT? A4
"A"
Current consumption unit: XXXX mA
Charging: XXXX mA 
Press "" for the second
information window.
""
81
Low capacity voltage diff: XXXXX mV

Press "" for the first
information window.
"Return"
Display current consumption in unit
ACCEPT? A4
Scroll or press "Return" to
H5.
"Return"
Service
ACCEPT? H5
Scroll or press "Return".
NOTE! Each window is updated continuously.
81
This window will not be visible until 4 hours after the c.i.e. is powered and
the batteries have to be connected.