Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: - EBL128 Operating Instructions V2.0.x
3
16.2 Fire alarm _______________________________________ 42
16.2.1 Fire alarm menu (X1-X9) _______________________ 45
16.2.2 Alert Annunciation alarm (AA alarm) _____________ 48
16.2.3 Co-incidence alarm (two-unit / -zone dependence) ___ 49
16.3 Heavy smoke alarm / Heavy heat alarm ________________ 49
16.4 Key cabinet alarm _________________________________ 50
16.4.1 Key cabinet opened before a fire alarm_____________ 50
16.4.2 Key cabinet opened in conjunction with a fire alarm __ 51
16.5 Quiet alarm ______________________________________ 51
16.6 Alarm Acknowledgement Facility (AAF) _______________ 51
17 Alarm reset _______________________________ 53
17.1 Pre-warning reset _________________________________ 53
17.2 Fire alarm reset ___________________________________ 53
17.2.1 All _________________________________________ 53
17.2.2 Single_______________________________________ 53
17.2.3 Single with automatic disablement ________________ 54
17.2.4 Co-incidence alarm ____________________________ 55
17.3 Heavy smoke / heat alarm reset ______________________ 55
17.4 Key cabinet alarm reset _____________________________ 55
17.5 Quiet alarm reset __________________________________ 55
17.6 Alarm Acknowledgement Facility (AAF) reset __________ 55
17.7 Acknowledged alarm ______________________________ 56
17.8 Isolated alarm ____________________________________ 56
18 Fault _____________________________________ 57
18.1 Fault messages ___________________________________ 58
18.2 Fault acknowledge ________________________________ 70
19 Commissioning an EBL128 __________________ 71
20 SSD programming & download ______________ 72
20.1 SSD programming _________________________________ 72
20.2 Auto generating SSD _______________________________ 72
20.3 SSD download ____________________________________ 72
20.4 Download of Alarm texts ___________________________ 74
21 Software (S/W) download ___________________ 75
21.1 Download of S/W in EBL128 (c.i.e.) __________________ 75
21.2 Earlier S/W version download _______________________ 76
21.3 S/W download in Display Units ______________________ 76
22 Restart ___________________________________ 77
22.1 Boot menu _______________________________________ 79
23 Access ____________________________________ 81
24 Perform monthly test (H1) ___________________ 83
25 Disable or re-enable (H2) ____________________ 85
25.1 Disable zone (H2/B1) ______________________________ 86
25.2 Disable zone / address (H2/B2) _______________________ 87