Panasonic FP0H - Page 147

10.2 System Register Settings
10-7
 System register relating to high-speed counter output
Classification
No. and setting item
Settings
Controller input settings
(HSC/PLS)
400
HSC
operation mode
setting
(X0 to X2)
CH0
Not set X0 as High-speed counter
2-phase input (X0, X1)
2-phase input (X0, X1) Reset input (X2)
Addition input (X0)
Addition input (X0) Reset input (X2)
Subtraction input (X0)
Subtraction input (X0) Reset input (X2)
Individual input (X0, X1)
Individual input (X0, X1) Reset input (X2)
Direction distinction (X0, X1)
Direction distinction (X0, X1) Reset input (X2)
J-point positioning start input of pulse output CH0 (X0)
CH1
Not set X1 as High-speed counter
Addition input (X1)
Addition input (X1) Reset input (X2)
Subtraction input (X1)
Subtraction input (X1) Reset input (X2
J-point positioning start input of pulse output CH1 (X1)
401
HSC
operation mode
setting
(X3 to X5)
CH2
Not set X3 as High-speed counter
2-phase input (X3, X4)
2-phase input (X3, X4) Reset input (X5)
Addition input (X3)
Addition input (X3) Reset input (X5)
Subtraction input (X3)
Subtraction input (X3) Reset input (X5)
Individual input (X3, X4)
Individual input (X3, X4) Reset input (X5)
Direction distinction (X3, X4)
Direction distinction (X3, X4) Reset input (X5)
J-point positioning start input of pulse output CH2 (X3)
CH3
Not set X4 as High-speed counter
Addition input (X4)
Addition input (X4) Reset input (X5)
Subtraction input (X4)
Subtraction input (X4) Reset input (X5)
J-point positioning start input of pulse output CH3 (X4)
(Note 1): Displayed item names and ranges vary according to the types of control unit.
(Note 2): Select "Not set XX as High Speed Counter" for the input that is not used for the high-speed counter function.