Panasonic FP0H

Settings of Control Unit
4-20
 Settings when using table setting mode
Parameter
name
No. and setting item
Settings
Controller
input settings
(HSC/PLS)
400
HSC operation mode
setting
(X0 to X2)
CH0
Not Set X0 as High Speed Counter
2 phase input (X0, X1)
2 phase input (X0, X1) Reset input (X2)
Addition input (X0)
Addition input (X0) Reset input (X2)
Subtraction input (X0)
Subtraction input (X0) Reset input (X2)
Individual input (X0, X1)
Individual input (X0, X1) Reset input (X2)
Direction distinction (X0, X1)
Direction distinction (X0, X1) Reset input (X2)
J-point positioning start input of pulse output CH0 (X0)
CH1
Not Set X1 as High Speed Counter
Addition input (X1)
Addition input (X1) Reset input (X2)
Subtraction input (X1)
Subtraction input (X1) Reset input (X2)
J-point positioning start input of pulse output CH1 (X1)
401
HSC operation mode
setting
(X3 to X5)
CH2
Not Set X3 as High Speed Counter
2 phase input (X3, X4)
2 phase input (X3, X4) Reset input (X5)
Addition input (X3)
Addition input (X3) Reset input (X5)
Subtraction input (X3)
Subtraction input (X3) Reset input (X5)
Individual input (X3, X4)
Individual input (X3, X4) Reset input (X5)
Direction distinction (X3, X4)
Direction distinction (X3, X4) Reset input (X5)
J-point positioning start input of pulse output CH2 (X3)
CH3
Not Set X4 as High Speed Counter
Addition input (X4)
Addition input (X4) Reset input (X5)
Subtraction input (X4)
Subtraction input (X4) Reset input (X5)
J-point positioning start input of pulse output CH3 (X4)
Controller
output
settings
(PLS/PWM)
407
Positioning control mode
setting
[FP0H mode] Table setting mode, FPΣ compatible instruction
mode
[FPΣ mode] FPΣ compatible instruction mode
402
Pulse/PWM output
setting
(Y0 to YC)
CH0
Select the output allocated to each channel.
Normal output, PWM output, Pulse output [Table setting
mode], Pulse output [FPΣ compatible instruction mode]
This setting cannot be selected in the FPΣ mode.
CH1
CH2
CH3
(Note 1): Displayed items vary according to models.
(Note 2): Select "Normal input" and "Normal output" for the input and output that is not used for the pulse output
function or high-speed counter function.
(Note 3): "J-point positioning start input" for each channel can be selected only when "Table setting mode" is set in
the system register no. 407.
REFERENCE
For details of the FPΣ mode, refer to "11. FPΣ Mode".