Panasonic KX-NS300 - Page 159

2.
Select Delete.
3.
Click OK to confirm.
The card will be removed.
Note
The cards in Slot No.1-No.3 of the Basic Unit and the card in Slot No.1 of the Expansion Unit cannot
be deleted because these cards are pre-installed.
To display the status information of a card
1.
Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2.
Select Status.
The status information of the card will be displayed in a pop-up window.
To change the status (INS/OUS) of a card (On-line mode only)
1.
Move the mouse pointer over the card.
A menu will be shown under the mouse pointer.
2.
Select the desired status:
• Click INS to set the card to in-service status.
• Click OUS to set the card to out-of-service status.
To access IP-PT port properties
1.
When you place the mouse cursor over the IP Phone Registration button on the Slot screen, the
following choices appear. Click an option to open a port properties programming screen:
IP-PT: For KX-NT300/KX-NT500 series and KX-NT265 (software version 2.00 or later) IP-PTs
(→ 9.14 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-IPEXT)
SIP-MLT: For KX-UT series SIP phones, S-PSs, and SIP-CSs
(→ 9.20 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-UTEXT)
Standard SIP Phone: For third party SIP Phones
(→ 9.16 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPEXT)
Option: Opens the Site Property—Main screen.
(→ 9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Main)
9.1 PBX Configuration—[1-1] Configuration—Slot
PC Programming Manual 159