Panasonic KX-NS300 - 9.30 PBX Configuration-[1-1] Configuration-Slot-Card Property-E1 type MFC-R2 Setting 1

9.30 PBX Configuration—[1-1] Configuration—Slot
—Card Property—E1 type MFC-R2 Setting 1
Name Description Value Range Links
ANI Service—Mode Selects the ANI (Automatic Number
Identification) service mode.
None: ANI service is
not activated.
Incoming call only:
Receives the caller’s
number from the E1
line.
Outgoing call only:
Sends the caller’s
number to the E1 line.
Both calls: Sends and
receives the caller’s
number through the
E1 line.
ANI Service—ANI Max.
digits
Specifies the maximum number of digits
to be received via ANI when receiving a
call with ANI.
None, 1–16
MFC-R2 Timer—Forward Specifies the maximum time that the
PBX waits for an MFC-R2 forward
signal sent from the telephone
company.
1–30 s
MFC-R2 Timer—Backward Specifies the maximum time that the
PBX waits for an MFC-R2 backward
signal sent from the telephone
company.
1–30 s
MFC-R2 Timer—
Disappearance
Specifies the maximum time that the
PBX waits for an MFC-R2
disappearance signal sent from the
telephone company.
1–30 s
Group-l Code Assignment—
ANI Start
Specifies the code used to indicate the
beginning of an ANI number.
Undefined, 1–15
Group-l Code Assignment—
ANI Complete (1)–(4)
Specifies the code used to indicate the
end of an ANI number.
ANI Complete (1): 1–
15
ANI Complete (2)–(4):
Undefined, 1–15
Group-l Code Assignment—
ANI Reject
Specifies the code used to reject an ANI
number.
1–15
Group-l Code Assignment—
End of Digit
Specifies the code used to recognise
the end of each digit in an ANI number.
Undefined, 1–15
Group-l Code Assignment—
End of Digit Timer
Specifies the length of time that the
PBX waits for further signal before
detecting the end of digit of an ANI
number.
1–15
9.30 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type MFC-R2 Setting 1
PC Programming Manual 291