Name Description Value Range Links
FWD
Destination for
Call from
Extension
Indicates the forwarding
destination of incoming
intercom calls (reference
only).
Max. 32 digits
(consisting of 0–9,
*, #, [ ] [Secret],
and P [Pause])
PC Programming Manual
References
12.1.2 PBX Configuration—
[4-1-2] Extension—Wired
Extension—FWD/DND
Feature Manual References
2.3.2 Call Forwarding (FWD)
FWD No
Answer Time
Specifies the length of time
that an incoming call rings
at the extension before the
call is forwarded.
0–120 s
PC Programming Manual
References
12.1.2 PBX Configuration—
[4-1-2] Extension—Wired
Extension—FWD/DND
Feature Manual References
2.3.2 Call Forwarding (FWD)
Keep ring after
FWD NA to CO
Specifies whether an
extension continues to ring
after forwarding an
incoming call to an outside
destination via FWD N/A or
FWD Busy N/A.
Disable, Enable
PC Programming Manual
References
12.1.2 PBX Configuration—
[4-1-2] Extension—Wired
Extension—FWD/DND
Feature Manual References
2.3.2 Call Forwarding (FWD)
Remote FWD
COS
Specifies the COS that
allows the FWD setting on
the extension to be
changed from another
extension. This COS must
then be set for the
extensions that will
remotely change the FWD
setting.
Disable, 1–64
Feature Manual References
2.3.2 Call Forwarding (FWD)
12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—
Extension Settings—CLIP Generate
CLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together. Pre-
assigned CLIP numbers for those locations will be overwritten.
If a number generated here is longer than 16 digits, the additional digits will be discarded.
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
PC Programming Manual 441
To Next Page
Loading...
