Name Description Value Range Links
Services—
Two-way
Recording
Specifies the number of UM ports
reserved in Services—Unified
message to use for Two-way
Recording.
0–24 ports (cannot
exceed the value set in
Services—Unified
message)
Feature Manual
References
5.5.4 DSP
Resource Usage
Services—
OGM
Specifies the number of OGM ports
to reserve DSP resources for.
0–64 ports
Feature Manual
References
5.5.4 DSP
Resource Usage
Services—
Conference
trunk
Specifies the number of conference
rooms to reserve DSP resources
for.
0–24 conference rooms
Feature Manual
References
5.5.4 DSP
Resource Usage
Services—
Free resources
(G.711)
Indicates the amount of free DSP
resources available to allocate
(reference only).
0–252 DSP resources
0–61 DSP resources (as
a Slave unit in a One-look
network)
Feature Manual
References
5.5.4 DSP
Resource Usage
Select a time
to apply the set
values
Specifies when the settings made
on this screen are applied.
Note
Any calls being made that use
DSP resources will be
disconnected when setting
values are changed and
applied.
• Set: Specify a date and
time to apply the
changes, and click OK.
The changes will be
applied at the specified
date and time.
• Apply now: The
changes are applied
immediately. Click OK
to apply the settings
immediately.
9.38.1.1 PBX Configuration—[1-5-1] Configuration—DSP Resource—
Setting—DSP Resource Advisor
The DSP Resource Advisor assists programmers in the allocation of DSP resources to various PBX
functions.
1. Note the value of Total Power. This is the total capacity for allocating DSP resources, depending on
the DSP card installed in the PBX.
2. In the Ports column, enter the number of ports to allocate to each PBX function.
3. For voice calls, it is useful to estimate how often each call function is used, as every extension or trunk
is not in use all the time. In the Busy Ratio (%) column, specify the anticipated ratio of time the type of
voice call function will be used.
4. As values are entered, the values in the Power column will increase to reflect the resource required for
the input amounts. Likewise, the value for Free resources (G.711) will decrease.
Note
Click Clear to reset the input values and start again.
5. When all items are allocated, confirm that the amount of resources input does not exceed the value
indicated in Total Power.
9.38.1 PBX Configuration—[1-5-1] Configuration—DSP Resource—Setting
308 PC Programming Manual
To Next Page
Loading...
